YAKATTACK MIGHTYMOUNT SWITCH

Instructions for Rotomolded and ABS Kayaks: **Please do not use Loctite or a threadlocker that reacts with plastics**         

1. Locate the Hardware for Deck Mount Installs

2. Position the MightyMount Switch on the surface where you want to install it.

3. Using a hole in the MightyMount Switch as a guide, drill the first hole using a 17/64” drill bit.

4. Drop a LONG 1/4?20 screw through the MightyMount Switch and into the drilled hole. This will prevent the MightyMount Switch from sliding around as other holes are drilled.

5. Repeat steps 2 and 3 for the rest of the holes.

6. Once all holes are drilled, remove all screws.

7. Apply marine sealant as desired into hole and/or on screw threads.

8. Install first screw with washer and nut on inside of hull, but do not fully tighten.

9. Repeat steps 6 and 7 for remainder of screws.

10. After all screws are installed, fully tighten, being careful not to over tighten.